![]() Note: User can baseline at any time using the TEMP RESET button.ġ0. +5 degree Sound OFF / -5 degree Sound OFF - Press and hold the TEMP RESET button until LED’s sequence all RED, all BLUE and then back to all RED and then quickly release the button while the LED’s are on.ĭ. +5 degree Sound ON / -5 degree Sound OFF - Press and hold the TEMP RESET button until all BLUE LED’s are illuminated, then quickly release the button while the LED’s are on.Ĭ. +5 degree Sound OFF / -5 degree Sound ON - Press and hold the TEMP RESET button until all RED LED’s are illuminated, then quickly release the button while the LED’s are on.ī. The sound (tones) can be turned OFF using the following procedure:Ī. There are five individual ascending tones for +5 degree, and five individual descending tones for a -5 degree change. To turn this ON, slide the switch located on the left side of the P-SB11 to “TEMP.” This circuit is designed specifically to detect +5 / -5 degree Hot & Cold spots using RED LED’s for (+) and BLUE LED’s for (-). TEMPERATURE - The P-SB11 has ambient temperature deviation detection (ATDD) built into it. Note: Reception of very strong channels can still occur. The following combinations are possible:Ĭ. ANTENNA SWITCH – Depending on personal preferences, the AM/FM antenna switch located on the side of the P-SB11 can be used to connect or disconnect the AM coil and FM telescopic antenna from the P-SB11 circuit. If FM/FM or AM/AM dual sweep is selected for CHN 1 & CHN 2, two RED (FM) or BLUE (AM) LED’s will appear in the sweep SPEED LED array.Ĩ. The AM LED array sweep speed is identified using a BLUE positional LED. ![]() The FM sweep speed is identified using a RED positional LED. The AM is adjustable from 50 thru 350 milli-seconds (mS). SWEEP RATE - The FM sweep rate is adjustable in steps from 50 thru 300 milli-seconds (mS). Tap the button to pause and resume the sweep.ħ. A RED LED will turn ON when the sweep is active. ![]() SWEEP DIRECTION - Press and hold the sweep REV (Reverse) or FWD (Forward) momentary buttons for about two seconds to initiate the sweep. In addition, deactivating the AM or FM Antenna can greatly affect the reception volume, especially in the AM sweep mode.Ħ. Thus, you may want to adjust the AM louder to create a more balanced sound in accordance to individual listening preferences. For example, if you have CH1 on FM and CHN 2 on AM, the volume on the AM may be softer. The Volume can vary depending on P-SB11 setting variables. VOLUME - Adjust CHN 1 & CHN 2 volume by pressing and holding the VOL + and VOL – buttons. Also note that the AM/FM LED light will blink at the same rate as the sweep rate selected.ĥ. You can perform a single sweep AM/FM individually or dual sweep FM/FM, AM/AM or AM/FM. Above the button is an LED indicator, FM is identified with a RED color and AM is identified with a BLUE color. AM/FM SELECTION – Tap the AM-FM button to select AM or FM. FUNCTION - Use the FUNCTION button to select and toggle between CHN 1, CHN 2 single sweep, or CHN 1 & CHN 2 simultaneously dual sweep operation.Ĥ. ![]() POWER - Slide the POWER OFF-ON switch to the ON position and CHN 1 & CHN 2 will default to the FM frequency.ģ. Be sure to attach the +/- polarity correctly to ensure proper operation.Ģ. BATTERY - Remove the battery hatch cover and insert a 9VDC Alkaline Battery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |